Putting a system into Setup mode

1. If an Ethernet cable is connected to the back of the soundbar, disconnect it.
2. Turn the soundbar on to the SoundTouch source by pressing the SoundTouch button on the remote control.
3. Press-and-hold the 9 button until all the lights on the soundbar flash.
   The Wi-Fi status indicator light on the soundbar will illuminate and glow amber while in Setup mode.

For the next steps, refer to the SoundTouch app or instructions that asked you to enter Setup mode.
If the Ethernet cable (that was connected to the soundbar) is on the same network as your device running the SoundTouch app, you can reconnect it to the soundbar after it appears in the app.