Putting a system into Setup mode

1. If an Ethernet cable is connected to the back of the SoundTouch pedestal, disconnect it.
2. On the back of the pedestal, press-and-hold the Control button for about 3 seconds.
   Note: Holding the Control button for 10 seconds or longer will reboot the pedestal; So, if the light does not glow amber within a few seconds, release the button and try again.
   
    
3. Wait until the Wi-Fi status indicator light glows amber, then release the button.
   "SETUP SEE INSTRUCTIONS" appears in the display and the Wi-Fi status indicator will glow amber while in Setup mode.

For the next steps, refer to the SoundTouch app or instructions that asked you to enter Setup mode.
If the Ethernet cable (that was connected to the pedestal) is on the same network as your device running the SoundTouch app, you can reconnect it to the pedestal after the Wave system appears in the app.