No audio from product

The Hi/Lo switch on the audio cable connector is useful if audio is too loud or too quiet in the headset, even after adjusting volume. Be sure it is set properly. For more info, see Setting the audio attenuation Hi/Lo switch.

Its possible the volume is too low or muted. Increase the volume gradually

Electronics might need to be reset from time-to-time—much like rebooting a computer. Power off the device, then power it back on and try again.

To produce sound and cancel noise, they headset must be powered on. Flip the switch on the right earcup to the on position: If the green light does not turn on, see No power.

For the best sound quality the input cable must be securely connected at both ends. This may require an extra amount of pressure to properly seat the cable into the earcup. Carefully, but firmly, press the connector into its socket at the earcup until a slight click is felt.

Two audio cables were included with your headphones. Connect your headphones to the same audio device with both cables to determine if the issue is one of the cables.

If the issue only occurs with a particular app, it is likely related to the app or app settings.

If your product connects to the device using an extension cable or adapter, disconnect the extension cable or adapter to determine if the issue is related to it.

If the steps provided do not resolve your issue, your product may need service. Follow the link below for more information on how to service your product. Depending on your product and region, you will be provided a contact number or the ability to setup service online.

Click here to start service